Silicone seal Elring Dirko HT - Profipress

Chemical base: Oxime silicone
Curing: room temperature curing (RTV)
Components: one-component
Colour: black
Consistency: pasty, stable, permanently elastic when cross-linked
Temperature range: -60°C to +285°C (up to +315°C over 24 hours)
Maximum sealing gap: 2.0 mm
pH value: neutral
Electrical conductivity: insulating
Resistance to: Mineral oils (also with additives), synthetic oils, lubricating greases, coolants, UV radiation, cold and hot water, salt water, cleaning agents, weak acids and alkalis
Possible areas of application: Valve cover, oil pan, water and oil pump, differential housing, transmission housing, transmission oil pan, thermostat housing, control housing, axle cover, flange connection, headlight, tail light, battery box and much more.
Instructions for use
- Remove sealing residue and clean the sealing surfaces with solvent
- Sealing surfaces must be clean, dry and free of oil and grease before applying the sealant
- Apply the sealant continuously and evenly. The application speed can be regulated by operating the lever
- Remove any excess sealant immediately, as there is a risk of dripping.
- Assemble components according to manufacturer's instructions
- Immediate sealing function is provided
- Close the sealant after use. All 3 screw connections of the adapter should be tightly screwed down for reuse.